Vojta
Mechanical
- Mar 27, 2017
- 1
Hi,
Is there a way how to make parameter(expression) from results of Check-Mate checks? How can that be done?
It can be related either to single checks (like "sketches fully constrained = true") or related to all tests what has been done like( "Problems found = 0")
The reason why I want to have this parameter is, that my PLM system (which is not TeamCenter) can read the parameter.
regards
Vojta
Is there a way how to make parameter(expression) from results of Check-Mate checks? How can that be done?
It can be related either to single checks (like "sketches fully constrained = true") or related to all tests what has been done like( "Problems found = 0")
The reason why I want to have this parameter is, that my PLM system (which is not TeamCenter) can read the parameter.
regards
Vojta
