Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

nx constraint validation Solution

Thread starter Michel1978
Start date Oct 14, 2016

Status: Not open for further replies.

Oct 14, 2016

Michel1978

Mechanical

thread561-379792

I found the solution for thread561-379792. It is just a setting.
In the customer defaults - Assemblies - General - Product Interfaces, the "Assembly constraints" was set on "Encourage Use of Interface Object". This caused the warning every time I added a component to an assembly.

Regards, Michel

Groeten, Michel

I use NX9.0.0.19
HP Z420 Intel Xeon 3.2GHz
Quadro K4000 3GB
64GB Memory
Windows 7, 64-bit

http://www.kvi.nl

A leading Dutch institute in atomic and subatomic physics