I am using the deviation gauge to measure the difference between planar splines (half circles) to a cylindrical surface. I have a grasp of how most everything works within the operator. The one item I cannot figure out is the Positive Inner and Positive Outer fields under Tolerance. Do the tolerances base themselves off of the target object or the reference object?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX Deviation gauge
- Thread starter uglord78
- Start date
