Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX - DMAP urgent information required

Thread starter nastranuser123
Start date Apr 29, 2014

Status: Not open for further replies.

Apr 29, 2014

nastranuser123

Structural

I am looking in detail at the programmers guide to work out how to access and modify NX DMAP programs from there. Basically it seems to be by modifying the the executive control section of NX input files.

Can anyone help and advise it is possible to write additional code in, say, FORTRAN or C++, and then call those routines from a DMAP program?

Regards
Christy