NX ELECTRIC. HOW TO DESIGN A CABLE WITHOUT STOCK FILES?

[Bogdan1985]

Hey,

I have to create a wire harness but I tried first with a dummy test. Unfortunately I have no stock for the wires/cables, I have the centerlines only. [See attached image].

1.) How can I design the cables over the centerline without having a stock file.
1.2.) How can I assign a stock file for wires?

2.) In case the problem 1.) is solved, where is the button to isolate this as a harness, so that NX offered
this part as a harness part.

Thanks,
See image

 

[Rob_N]

I'm not sure if I'm undertanding the question, but to model a Wire using a center line.
Try the Tube command, just leave the Inner Diameter at zero

https://docs.plm.automation.siemens.com/tdoc/nx/12.0.2/nx_help/#goto:modeling:feat_tube_op