NX Hole Table - Custom Headings

[Srouleau11]

Is there a way to edit the hole table in NX Drafting. What I mean is The default hole table combines the holes into groups, which we do not want. See Attached File.

I can't figure out where the hole table is pulling the information from, therefore I cannot edit what information goes where. Any Help editing the table would be great

 

[JohnRBaker]

Go to Customer Defaults and search on "hole table". You will get a couple dozen hits. Check them out as this is the only place that I think we provide any sort of setting of options.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.