nxexplorer
Mechanical
- Jun 23, 2010
- 84
Hello All,
I need help with the existing NC Code output with NX Post Builder. It is on how to make the coordinate output G01X.25Y-.573 become G01X0.25Y-0.573
Any suggest so much appreciated.
Best Regards,
Maryadi
I need help with the existing NC Code output with NX Post Builder. It is on how to make the coordinate output G01X.25Y-.573 become G01X0.25Y-0.573
Any suggest so much appreciated.
Best Regards,
Maryadi