Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX units conversion utility

Status
Not open for further replies.
Replies continue below

Recommended for you

When you start the utility, you must first set your license server in the script. Should look something like this;

Code:
@echo off
Set SPLM_LICENSE_SERVER=28000@"your licenseserver name or IP"
call ug_convert_part "your part nr and other switches needed"

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX12 / TC11
 
I suggest running the utility from the NX command prompt (windows start -> Siemens NX 9 -> tools); this will execute a .bat file that will set up the environment for NX and its utility programs.

www.nxjournaling.com
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor