NX11 Adding Exploded View To Face Of Drawing? 1

[4mranch6]

I have created an Exploded View in the Drafting Application on the Model side. Now I cannot figure out how to add it to the face of the drawing. Can someone please point me in the right direction?

When I go to Menu / Insert / View / Base..., I cannot locate where this new Exploded View is so I can select it and place it on the face of the drawing.

Thanks in advance

 

[cowski]

When inserting the base view, make sure that the drawing file is selected in the "part selection" (at the top of the dialog, it may be collapsed). NX likes to default to the part file instead of the drawing file. Once the drawing file is selected, the exploded view should appear in the list of views to use.

www.nxjournaling.com

 

[4mranch6]

Thank you cowski for the rapid response time and advice, that works! I had searched online and in this forum to no avail.