NX12 Drafting Vs. NX 1926 Drafting - Subject Sketch

[BrittToolEngineer]

Greetings:

In NX12, when drafting, I am able to type the letter "L" and this begins sketch mode with the line command. In NX 1926, when I type the letter "L", nothing occurs. I have to find the line command in the sketch application to perform this. I'm wondering if there is a toggle somewhere in NX 1926 to enable typing "L" to start sketch mode in drafting?

Thank you in advance for helping.

Brent

 

[Toost]

I had a look, between NX12 and NX 1953 ( which is the only other version I have installed) a few shortcuts have disappeared, L for Line, O for full circle , S for Spline and P for Polygon.
I Do not know why these disappeared.
I guess "they think" that z for profile will do what the line does, but the others ?

Regards,
Tomas

 

[Arkance/PhoeNX]

For some reason they've been assigned to the sketch scene bar for the relations.

Anthony Galante
Senior Support Engineer


NX4 to NX CR with almost every MR (18versions)