Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX1884 Extrude

Status
Not open for further replies.
jerry1423

jerry1423

Mechanical
Aug 19, 2005
3,428
Has the ability to extrude a solid edge been removed in NX1884 ?
It appears that I can only extrude a sketch curve now, but I am able to select an edge.

Jerry J.
UGV5-NX1884
 
Replies continue below

Recommended for you

Sort by date Sort by votes
I can in 1919, skipped over 1884.

Rob
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Anton Liubimov
  • Locked
  • Question
NxOpen, How to programmatically open a dialog box "Extrude"
Replies
2
Views
347
Anton Liubimov
Anton Liubimov
NXsupport
  • Question
Is there a way to make extrude dialog remember the limits options set in the dialogbox
Replies
2
Views
1K
Bleaker
Bleaker
imti7
  • Locked
  • Question
not able to use 'Until selected' in extrude 1
Replies
3
Views
200
jerry1423
jerry1423
tallard
  • Locked
  • Question
Wrapping a sketch around a complex surface to extrude into a solid
2
Replies
20
Views
383
tallard
tallard
BOPdesigner
  • Locked
  • Question
NX 12 - Extrude dialog settings stuck on Sheet instead of Solid 1
Replies
3
Views
148
cowski
cowski

Part and Inventory Search

Sponsor

Back
Top Bottom