Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX2 Plotting - Repeating Pages

Thread starter wanabi
Start date Feb 15, 2005

Status: Not open for further replies.

Feb 15, 2005

wanabi

Automotive

I have a plot queue setup to a laser printer. Two queues, 1 for 8x11 and 1 for 11x17. Same printer and configuration since version 16 and never had a problem. Now with NX2 it plots the same thing over and over again until the printer is reset. I also have a queue setup to a plotter. The plotter works fine. GTAC has no idea.

Anyone seen this?