NX3 ASSEMBLIES

[TomMtz]

Friends

I have a problem in NX3, when I try to add a new component in other file with his sketch.
The only way that I found was "eliminating all parameters"., this is problem for me because I need to change some dimensions in the sketch or expression chart to modify my model.
And that way results in use only a "solid part" instead of using a complete body with all parameters "live".

Thanks for your help

 

[cowski]

Do you get an error message? if so what does it say?

It sounds like you might be trying to add a part created in a later version of NX?

 

[TomMtz]

Cowski

both files were created in NX3, and it doesn´t launch an error message.

 

[JohnRBaker]

I'm afraid that you're going to have to do a better job of describing what it is that you're doing and what it is that you expect to happen. And the part files would be useful as well.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.