HydraulicEngineer
Mechanical
I just use NX5 today. Unfortunately I can't analyze the surface which can be done in NX4. any one can tell me where the icon is? Thanks a lot
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX5 Analysis Surface
- Thread starter HydraulicEngineer
- Start date
- Status
Switch to one of the Advanced roles if you haven't already.
Tim Flater
Senior Designer
Enkei America, Inc.
Some people are like slinkies....they don't really have a purpose, but they still bring a smile to your face when you push them down the stairs.
Tim Flater
Senior Designer
Enkei America, Inc.
Some people are like slinkies....they don't really have a purpose, but they still bring a smile to your face when you push them down the stairs.
- Status