NX5 Dart Operator

[tomcatcool17]

I've been using the dart command in NX5 and I notice that it will only make a dart at 45 degrees in relation to the 2 faces selected. Is there a way to change this angle in the operator so the dart is 30 degrees in relation to one of the faces selected? The angle option in the dialog box is for the width, and the orientation plane doesn't do it either. I'm not too familiar with it, so I'm reaching out for help.

 

[hudson888]

If you mean that you want the same control as for an asymmetric chamfer then I think you're out of luck

Best Regards

Hudson

www.jamb.com.au

Nil Desperandum illegitimi non carborundum