Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX5; PMI surface finish max/min not avail for ANSI std

Thread starter potrero
Start date Jul 8, 2008

Status: Not open for further replies.

Jul 8, 2008

potrero

Mechanical

Using the 3D PMI module, ASME Y14.5M-1994 standard, ANSI surface finish symbols, the option is not present to utilize maximum/minimum roughness range, even though this should be an option (ie per ASME Y14.36M).

Is there a way to do this that I'm not aware of, or is this known, desired behavior?

Thanks.