NX8.5 2D Chamfer Recognition

[jpate92]

Hello all,

I have a drawing that has two chamfers on it. One is recognized by the chamfer dimension tool and one is not. What causes this difference?

A note to this: The chamfers are part of a link feature. But this includes both of them so it still doesn't help me with why one is recognized and the other isn't. I have tried using the "Label Chamfer" feature (Synchronous). This doesn't change the 2D output.

Any ideas?

Thanks,

John

 

[cowski]

In drafting, the chamfer dimension only applies to chamfers at 45°. For chamfers at other angles, you need to supply more information on the drawing.

www.nxjournaling.com

 

[jpate92]

Well then, I guess that's that!

Thanks!