Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NXOpen motion simulation

Thread starter basenxuser
Start date May 11, 2017

Status: Not open for further replies.

May 11, 2017

basenxuser

Mechanical

Hello all,

I have requirements in motion simulation automation.

1. Need to iterate through joint drivers and suppress/unsuppress required drivers in NXOpen .Net.

2. Enable selection of joint drivers using NXOpen .Net.

Any suggestions or samples on this.

Thanks,
Hariharan B