Offset curve that lies on a surface has a gap at one end touch other.

[texaspete]

Hi gang it's me again with a problem; this is my problem. The last feature is an offset of a curve that is on a surface; Please notice both ends of the curve should touch the adjcent edges, one end is touching the edge of the surface. The other has a gap. It just pull away from the adject edge of the surface. I do not want the gap. Please advise me how to stop or fix.
I’m using wildfire 2.0 build m160
Thanks in advance - texaspete

 

[Guest0527211403]

pete-Can you upload a picture somewhere? I'm having a hard time visualizing your problem.

 

[texaspete]

Hi Justkeepgiviner, I have a picture, how can I get it to you, I have an account with

http://www.Mcadcentral.com;

I can upload to there I think.
Texaspete

 

[cadcamguy]

tex

http://www.filewind.com/