Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Oil Water Separation - Choosing the Right Equipment

Status
Not open for further replies.

wardens355

Civil/Environmental
Oct 1, 2012
17
I am working on a collection of commercial oilfield disposal sites and am diving in head first to the world of oil-water separation (OWS). The sites will have a truck wash, where recently emptied tankers and end-dump trucks with cutting wastes will wash off. The wastewater from the truck wash bays will be collected and pumped to oil-water separation. High suspended solids content and chlorides/TDS are anticipated. At the moment, I am looking into API separators ($$$), CPI separators ($$), and gun-barrel tanks ($). Gun-barrel tanks do not seem to have solids handling capabilities, and I have read that they are typically used for crude oil with little water. This application is mostly water with some oil & solids. Also, it seems as if CPI separators do not have the ability to handle large amounts of solids (clogging of packing). Does anyone have any suggestions, guidance, or recommendations for this?

The sites will also be accepting produced water & possibly frac water, and will be disposed of through deep-well injection. Pretreatment will also include oil-water separation. I am not sure if this water will be high in solids content, but it will have high TDS. Would both these applications likely use the same OWS type?

I have not looked into hydrocyclones or DAF/DGF much since they seem more complex and not as straight-forward to operate.

Any feedback would be appreciated, thanks!
 
Replies continue below

Recommended for you

Look into decanter or tricanter centrifuge technology.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor