Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

on-line air preheater cleaning

Status
Not open for further replies.

ponderer

Petroleum
Feb 5, 2003
40
0
0
TW
We have a balance draft heater in our crude distillation unit.

The flue gas from the heater first enter a De-NOX
reactor(Selective Catalytic Reduction), and then go through a preheater before entering the stack.

The preheater has two section, the top section is made of
steel, and bottom section is made of glass tube.

Who has experience to do on-line cleaning for the air preheater?

How often do you clean the air preheater?
 
Replies continue below

Recommended for you

We have a DEKA air preheater on a 115MM BTU fired heater. We clean with a water flush on a monthly basis. We have installed spray rails across the top of the unit. We drain the unit to a sump where the water is collected. The unit is bypassed during cleaning.
 
Without wishing to "market" oneself too obviously!

We at Polarchem remove fouling in CDUs and air heaters. The application of Polarchem (a nitrate based formula injected on-line into the radiation section in an aqueous solution) will remove/reduce the need for water washing.

I would be very happy to answer some more detailed questions.
Charles
 
Status
Not open for further replies.
Back
Top