Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Opening files of the same name but different folder.

Status
Not open for further replies.

CorBlimeyLimey

Mechanical
Joined
Nov 5, 2003
Messages
15,292
Location
CA
Just a survey for reference;

Can Wildfire have two or more files open of the same name but from different folders?

Word can, but Excel and SW cannot.
 
Pro/E cannot.
Neither can NX.

IF you can get a second session running, you may be able to the same part, but usually that is also a tricky feat.

"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
You can use the Analysis/compare part functionality to open a different version of the same part from the same or different folders. Pro/E will prompt you for a unique temporary name for the second version.
 
I run multiple sessions of pro-e and I can open files of the same name in different folders.
SrG.
 
SrG, how do you make sure you save the correct version?

I like that Pro/E prompts you to rename the file when opened a 2nd time. I mostly do this to review what was there before whatever dificulty created problems showed up. I would hate to have spent time correcting a problem, only to file the wrong version. Renaming the reference version makes it safer.

Peter Stockhausen
Senior Design Analyst (Checker)
Infotech Aerospace Services
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top