Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Opennings acc. UG36

Status
Not open for further replies.

Vitd

Petroleum
Oct 3, 2020
21
Hallo,

calculations acc. Div. 1 ASME

My nozzle is 73mm and it ia not adequately dimensioned acc. UG 37.

Can i now use UG 36 and say it is adequately dimensioned?

Thanks
 
Replies continue below

Recommended for you

If your nozzle is exempt from reinforcement calcs by UG-36, use this first and forget about UG-37.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor