Franklin M.
Aerospace
OK, that's a mouth full. actually 2 problems. I'm posting it here cause GTAC isn't helpful, getting the "company line" type answers.
Problem 1: NX V2206. Operations inside an program group were reordered by NX. Maybe related to instanced toolpaths as the group contained both regular operation and instances of the operations. We have tried to get it to repeat but so far all is well, won't repeat.
Problem 2: NX V2306. We're getting operations that get lost. Planar ops, the boundary appears to be getting translated away from where we created them. Again, a random and unpredictable issue.
If anyone has experienced either problem we would like to hear of your misery, shared misery is always better than suffering in silence. We are not sure what to do next, seek counseling or an exorcist?
Franklin
UG 10,13 & 18
NX 1,2,4,6,11,12,1899 & 2206
NCL502 (yep I love Sequential Mill)
Problem 1: NX V2206. Operations inside an program group were reordered by NX. Maybe related to instanced toolpaths as the group contained both regular operation and instances of the operations. We have tried to get it to repeat but so far all is well, won't repeat.
Problem 2: NX V2306. We're getting operations that get lost. Planar ops, the boundary appears to be getting translated away from where we created them. Again, a random and unpredictable issue.
If anyone has experienced either problem we would like to hear of your misery, shared misery is always better than suffering in silence. We are not sure what to do next, seek counseling or an exorcist?
Franklin
UG 10,13 & 18
NX 1,2,4,6,11,12,1899 & 2206
NCL502 (yep I love Sequential Mill)
