Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Optimation

Status
Not open for further replies.
rsands

rsands

Mechanical
Sep 25, 2002
6
I was wondering if anyone here had any experience using Solidworks with Optimation and if so what they did to link to the two programs together.

Thanks
 
Replies continue below

Recommended for you

Sort by date Sort by votes
We have been using Optimation with Unigraphics for over 10 years. We have a special filter set up to only take 1 layer out through IGES. The designer is responsible for creating the flat pattern. Optimation reads in the IGES to NCexpert. We also download shop orders directly from our MRP system.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom