Mar 14, 2014 #1 vipulpatel23111 Chemical Mar 14, 2014 4 How flow orifice orientation effect the reading of flow??
Mar 14, 2014 #2 pennpiper Mechanical Dec 9, 2005 1,687 Orientation? Of what? - The Line? - The Flange Taps? - The Plate? "Better Questions earn Better Answers? Jop prognosis: Lead or Lag Upvote 0 Downvote
Orientation? Of what? - The Line? - The Flange Taps? - The Plate? "Better Questions earn Better Answers? Jop prognosis: Lead or Lag
Mar 14, 2014 #3 hacksaw Mechanical Dec 7, 2002 2,570 for common plates there are correction factors for the inevitable case where it is installed backwards. but the question I think you are asking, is to install the paddle pointing upward Upvote 0 Downvote
for common plates there are correction factors for the inevitable case where it is installed backwards. but the question I think you are asking, is to install the paddle pointing upward
Mar 14, 2014 Thread starter #4 vipulpatel23111 Chemical Mar 14, 2014 4 If flow meter installed in verticle line, what is effect on flow reading? Upvote 0 Downvote
Mar 15, 2014 #5 hacksaw Mechanical Dec 7, 2002 2,570 usually no effect, but usually recommended that liquid flows-up or horizontal and gases with condensible components flow-down or horizontal. Upvote 0 Downvote
usually no effect, but usually recommended that liquid flows-up or horizontal and gases with condensible components flow-down or horizontal.
Mar 15, 2014 #6 PersonalProfile Mechanical Aug 24, 2003 258 I believe this has been done before, including the following, that is hopefully of use: http://www.eng-tips.com/viewthread.cfm?qid=250966 Regards, Lyle Upvote 0 Downvote
I believe this has been done before, including the following, that is hopefully of use: http://www.eng-tips.com/viewthread.cfm?qid=250966 Regards, Lyle
Mar 20, 2014 Thread starter #8 vipulpatel23111 Chemical Mar 14, 2014 4 In liquid stream if orifice installed in vertical line, than what will be effect on flow reading? Upvote 0 Downvote
Mar 22, 2014 #9 danw2 Industrial Oct 21, 2004 1,512 If you're looking for that magic number to make a correction with, you'll have to search the web yourself (good luck). If you want to know some of the effects of vertical flow on DP then try these links: David Spitzer comments on downward flow issues: [URL unfurl="true"]http://www.appliedmc.com/e-zine/MAR-08/downward-flow.html[/url] Vertical vs horizontal orifice plate runs was discussed here: [URL unfurl="true"]http://www.eng-tips.com/viewthread.cfm?qid=183271[/url] Upvote 0 Downvote
If you're looking for that magic number to make a correction with, you'll have to search the web yourself (good luck). If you want to know some of the effects of vertical flow on DP then try these links: David Spitzer comments on downward flow issues: [URL unfurl="true"]http://www.appliedmc.com/e-zine/MAR-08/downward-flow.html[/url] Vertical vs horizontal orifice plate runs was discussed here: [URL unfurl="true"]http://www.eng-tips.com/viewthread.cfm?qid=183271[/url]
