Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Output Data for NX5 Analysis

Status
Not open for further replies.

CCallaway

Aerospace
Joined
Jun 30, 2008
Messages
3
Location
US
I'm performing an analysis on a mechanism, I have set up a constraints for a specified range of motion. I was wondering if there was a way to obtain results at specific intervals (distances from my displacement constraints) without having to manually set up each interval and run each individual displacement. or is there a way to obtain the max reaction forces or stresses of the whole range of motion without doing a trial and error process at specific intervals to find the exact displacement that this occurs?


 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top