Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Outputing Tool Holder name to the APTSource

Status
Not open for further replies.
jlatva

jlatva

Mechanical
Aug 28, 2003
6
0
0
US
What I would like to know is how to output the Tool Holder (Tool Assembly) name from the PPTable?

*START_NC_INSTRUCTION NC_TOOL_ASSEMBLIES_CHANGE ???????????

*START_SEQUENCE

PPRINT/%MFG_NAME ?????????

*END

This is NOT working.
 
Status
Not open for further replies.

Similar threads

Bombas
  • Locked
  • Question
msgcatalog - name changes of front view e.t.c.
Replies
2
Views
18
Bombas
Bombas
Mirme.lee
  • Locked
  • Question
How to activate the sheet to which the selected view belongs?
Replies
3
Views
25
Mirme.lee
Mirme.lee
c800
  • Locked
  • Question
Need the code to get access to the properties and isolate the parts and save it 1
Replies
3
Views
30
Little Cthulhu
Little Cthulhu
Sriram V
  • Question
Finding Layup location in a tool by comparing surfaces in catia v5
Replies
0
Views
36
Sriram V
Sriram V
Sidtha
  • Locked
  • Question
How to extract the values from prodcut properties window
Replies
1
Views
18
Sidtha
Sidtha
Back
Top