Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Overmolding Polyurethane
- Thread starter Eddie1986
- Start date
ornerynorsk
Industrial
It is usually the more flexible material that is overmolded onto the more rigid material. Doing it the other way around will give you significant challenges or will be impossible. Ideally the bond is in-mold at the molecular level, no adhesives involved.
It is better to have enough ideas for some of them to be wrong, than to be always right by having no ideas at all.
It is better to have enough ideas for some of them to be wrong, than to be always right by having no ideas at all.
- Status
