I need help on how to build a list with Panelbuilder 32. I am designing controls for a machine that winds xfmr cores. This machine will wind one core at a time. After each core is wound, I would like to have a panel view screen that I can add the part number for that core to a list. After the operator winds a certain number of cores, he should go to the screen with this list, scroll through the list, and confirm that he has wound each of these cores individually. I would like some ideas on how to compile a list like this to a panel view screen.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
PanelBuilder 32....
- Thread starter JamesEspy
- Start date
jonesy29847
Electrical
What format will the data have?
How many do you wish to store?
Do you wish non-destructive storage?
I think you can imbed addresses in the message table.
How many do you wish to store?
Do you wish non-destructive storage?
I think you can imbed addresses in the message table.
- Status
Similar threads
- Locked
- Question