Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

parallel processing in Contact Pair

Status
Not open for further replies.
zahedi66

zahedi66

Mechanical
Apr 13, 2015
30
hello,
I have two kinematic constrained contact pair, How can I run a job in parallel mode? I have read about domain decomposition in abaqus manual but couldn't figure out how?
 
Status
Not open for further replies.

Similar threads

mj345
  • Question
contact generation
Replies
2
Views
237
mj345
mj345
Kamyar_K
  • Locked
  • Question
Contact Interaction and Gravity
Replies
3
Views
607
FEA way
FEA way
robertt3
  • Locked
  • Question
What's the default contact damping value in ABAQUS/Explicit
Replies
6
Views
406
Marekcom
Marekcom
AC1999
  • Locked
  • Question
Contact control automatic stabilization 1
Replies
9
Views
619
FEA way
FEA way
Bj3245
  • Locked
  • Question
Stent parallel plate compression
Replies
1
Views
48
FEA way
FEA way

Part and Inventory Search

Sponsor

Back
Top Bottom