Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Parameter - change step - not saved in part/product?

Thread starter Mechv5
Start date May 8, 2009

Status: Not open for further replies.

May 8, 2009

Mechv5

Mechanical

Hello,

I have a positioning parameter in a product and I want to modify the value of it only in 10 mm steps, so I'm using the "change step" option in the contextual menu and everything is ok. But if I close my product and open it again, the changing step of that parameter is again 1, as default... would it mean that I have to make a "change step" each time I open the file?

Regards,

Mechv5