Parameterization Analysis - Not able to record in MACRO

[DomKum]

Hi All,

I tried record a macro for getting the result of Parameterization Analysis to capture the results like
Unconstrained Sketch / Fully constrained sketch.

Unfortunately its not getting recorded and I am not aware of the reasons.

I tried searching in V5Automation.chm but could not figure out any useful information on this.

Please let me know your thoughts so that execute modeling checking by macro.

 

[ferdo]

Search section of the forum, maybe something like this

Regards
Fernando

https://www.youtube.com/playlist?list=PL9mSHa4SOedV3dr0D3kfIWFUg7mIYm94k

 

[DomKum]

Thank Ferdo for your input.
I understood taking output via setting but ow it is helpful for what I am looking for is not clear.
I tried follow but being a beginner in macro could not able to follow.

 

[solid7]

Not all APIs are exposed, and even fewer are available through record function. You should learn programming through the API documentation. It's a long, hard, road, if you haven't studied Computer Science and programming. But everything that you need to know - to get started, and a very long ways - is all in there.