Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Parameters for PF 700 and regen Unit

Status
Not open for further replies.
krsh

krsh

Electrical
Nov 10, 2010
54
Hello,
I am using a PowerFlex 700 drive for a pump jack application on a 500V not grounded power network. I want to install a regenerative unit(Revkon SVC) for this drive and i want to know what parameters i need to change. I also need to know what is the simplest way to know how much energy is regenerated.
Thank you.
 
Status
Not open for further replies.

Similar threads

T247
  • Locked
  • Question
Sync Motor PF Trip 7
2
Replies
27
Views
721
edison123
edison123
bacon4life
  • Question
Impacts of loss of excitation on small hydro unit 3
Replies
12
Views
3K
RRaghunath
RRaghunath
zaboli
  • Locked
  • Question
21 MW GE generator parameters
Replies
1
Views
112
Gr8blu
Gr8blu
EEENGRX
  • Question
Installation of float and pressure switch for motor control 2
Replies
10
Views
3K
SilverfoxUK
SilverfoxUK
NickParker
  • Question
AVR and Governor controller location for a Diesel Generator
Replies
3
Views
1K
NickParker
NickParker

Part and Inventory Search

Sponsor

Back
Top Bottom