Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Parameters List

Thread starter Adrian2
Start date Dec 15, 2006

Status: Not open for further replies.

Dec 15, 2006

Adrian2

Mechanical

Dear Folks;

In the parameters list, in Inventor 7, after you have been working with a part for some time and have replaced one parameter with another there are many unused parameters with 0 value.

Can you regenrate the parameters list so that these unused parameters dont show up anymore.

Best Regards

Adrian Dunevein
AAA Drafting Services

http://www.aaadrafting.com

http://home.cogeco.ca/~adunevein/

SW2006 Office Pro. SP4.1