Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Parameters to ProE vertices

Status
Not open for further replies.

iyermuku

Mechanical
Jan 29, 2008
2
In proE, a user cannot add parameters to Vertices. I have cross checked this and observed there is no selection filter for vertices in the Tools->Parameters Dialog.

However it appears, you can select a vertex for some commands. When I tested the selection of a vertex using ProSelectionModelitemGet, I got a modelitem whose type is one of

PRO_EDGE_START = 71,
PRO_EDGE_END = 72,
PRO_CRV_START = 74,
PRO_CRV_END = 75,

Is there a modelitem in proe for vertices? If there is, is there a command to access vertices,
say of an edge?

All these questions are driven towards the end goal of being able to create, set and get parameters
to and from vertices.

Help would be most appreciated.
Mukund Iyer Rajamony
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor