parametric study - change of initial conditions without exiting the simulation - Abaqus

[nelros]

Hi,
I am doinng an parametric study.
Therefore I need to change the inital conditions repeaditly wihtout closing abaqus.
I am capable of looping the simulation, but what I need is to loop the simulation without exiting the simulaiton itself otherwise the simulation would get into the queue (licence) again.
Is there a way of doing this?

Thank you!

 

[IceBreakerSours]

Yes. Search parameter in the documentation.

Are you new to this forum? If so, please read these FAQ:

http://www.eng-tips.com/faqs.cfm?fid=376

http://www.eng-tips.com/faqs.cfm?fid=1083