Part Family color

[cubalibre000]

Hi,
I've all my part families screws in gray color, but I would like to better represent the zinc galvanized or black galvanized color.
Is it possible to set a number in the column of excel to pilot the color of each family part ?

Thank you...

Using NX 8 and TC8.3

 

[JohnRBaker]

Yes, there is a way to do it since I've seen it done, but it uses KF (Knowledge Fusion) and unforunately I'm NOT a KF person.

I'll see if I can find out from someone what the steps are to do this and I'll get back to you.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.