Part Weight in Repeat region table

[PieBoy]

Hello all,

I have had a good search around this forum and the net for a solution to my problem.

I wish to put individual weights in a table on the assy drawing.

My model is in mmNs, and I want the weight in Kg's.

I followed this tut

http://www.proecentral.com/portal/articles/articlesDetail.asp?id=34

But my units on the drawing dont corispond to the calculated mass properties in the model. I know the mass is in Tonne but thats simple to convert, this values isn't even close to that.

Any help would be great.

Thank you.

 

[Hora]

PieBoy,

You can allways change the UNITS to mm Kg s. Create yourself a mapkey and repeat to all your parts and assemblies. I hope you don't have thousands in your top level.

And for thr future, setup units for template part, function of your needs.

Good luck.

-Hora

 

[Mike97D]

If you can't change the units, another way would be to create a relation that equals a new parameter for the weight in Tonne inside each part. Add that new parameter in the repeat region for the mass.