Silverbullet
Materials
I am looking to inhibit the water absorbtion properties of a silicone moulding. Can anybody advise if Parylene is the right material for this. Any other suggestions
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Parylene coatings 1
- Thread starter Silverbullet
- Start date
- Status
-
1
- #2
Back in 2002, Medical Device & Diagnostic Industry magazine had an article that explored various sterilization techniques on Parylene. One of the tests studied moisture vapor transmission (also called permeability) during steam sterilization.
They found a 43% change (I'm not sure, but I think they mean change in volume) with Parylene-N and a 5% change (deemed statistically insignificant) with Parylene-C. However they found a 17% change in tensile strength with Parylene-C and none with Parylene-N.
I admit this isn't a clear-cut answer for you, but hopefully it'll help.
They found a 43% change (I'm not sure, but I think they mean change in volume) with Parylene-N and a 5% change (deemed statistically insignificant) with Parylene-C. However they found a 17% change in tensile strength with Parylene-C and none with Parylene-N.
I admit this isn't a clear-cut answer for you, but hopefully it'll help.
- Status
Similar threads
- Locked
- Question
- Locked
- Question