SaeidII
Structural
- Dec 7, 2012
- 18
Hi,
Is it possible to set PATH=3 in Executive Control Section before analyzing the model?
I have already tried direct text input in that section but this command should be added after SOL command like:
SOL 700 PATH=3
I did not find any build in option to set this either. If you know how to do that please share.
Thanks.
Is it possible to set PATH=3 in Executive Control Section before analyzing the model?
I have already tried direct text input in that section but this command should be added after SOL command like:
SOL 700 PATH=3
I did not find any build in option to set this either. If you know how to do that please share.
Thanks.