Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pattern Question

Status
Not open for further replies.

Ebbie22

Mechanical
Joined
Oct 24, 2007
Messages
29
Location
US
Basically what I’m trying to do is link my cutout pattern to match up with the size of my part. So no matter what size the part is, the square cutouts will be filled in automatically throughout the entire part.

The square cut needs to be 2” X 2” with a .25” web in-between. As far as the web between the edges of my part the where the cut edge begins, this all needs to be centered within the perimeter of my part size no matter what size it is.

I know my explanation isn’t the greatest but hopefully someone will understand what I’m trying to do! :)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top