Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

PD5500 Conical Ends Greater than 60¦

Status
Not open for further replies.
Jonnox

Jonnox

Civil/Environmental
Joined
Mar 19, 2012
Messages
10
Location
GB
Hi All,

I was just wondering what rules to design too if my conical end half angle at the apex is greater than 60° as stated in PD5500.

If there's anything in PD5500 that's great if not i would be happy to look at other codes.

Best Regards
Jonno


 
Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

O
  • Question Question
How come BPVC S-N curves show stress amplitude greater than UTS
Replies
5
Views
6K
mfgenggear
mfgenggear
Akoll
  • Locked
A516 GR 60 vs A516 GR 70
Replies
10
Views
4K
Dhurjati Sen
Dhurjati Sen
daily123214
  • Locked
  • Question Question
Actual vessel thickness greater than nameplate
Replies
14
Views
432
r6155
r6155
FPPE
  • Locked
  • Solved
Equipment for performing weld overlay on nozzles smaller than 3 inches
Replies
11
Views
4K
FPPE
FPPE
TomRob142
  • Locked
  • Question Question
6" nozzle set into manway cover - PD5500
Replies
2
Views
521
DriveMeNuts
DriveMeNuts

Part and Inventory Search

Sponsor

Back
Top