PDM CHECK-IN PROBLEM 1

[tbeck11]

I just ran into a problem when checking in drawings to the vault. I was checking in a drawing that was going into the vault at Rev 4. During check-in, the description for Rev 0 was changed to the text I entered for Rev 4 and the description for Rev 4 was left blank. I tried deleting the rev block and adding a new one but that did nothing.

My VAR was able to duplicate this on different data and a different vault. This is a problem in PDMWorks Workgroup 2008 SP0.0 and 1.0.

Just wanted to let everyone know so that you can look at your rev blocks.

SolidWorks 2008 SP1.0

Todd

 

[PDMAdmin]

Thanks for the heads-up. That's a good thing to watch out for -- and for SW to fix.