PDM revisions and revisions on drawings 1

[dmark]

We're trying to set up PDMworks such that there are primary and secondary revisions. We'd use the secondary revisions as working copies and the primary revision as the official released rev's.

In other words, we'd have working copies of A-1, A-2, A-3, etc. and then do an official release at B.

Is there a way to get the revision block of the drawing to only show the primary revision and not the secondary?

-Dore

 

[fcsuper]

There is an option in the admin that allows you to set up the last rev as "optional" in the Revision Scheme tab; and also which level of rev to show in the rev block in the Revision Table tab.

Matt Lorono
Lorono's SolidWorks Resources & SolidWorks Legion

http://groups.yahoo.com/group/solidworks & http://twitter.com/fcsuper