TetT
Materials
- May 27, 2011
- 5
Hello
I use Abaqus CAE and I want to applied periodic boundaries conditions at one square RVE.
I want that tow parallel face have the same deform. I use Constrains -> Equation but when I choose set ( geometry ) I have the message : " All terms except the first one must use set consisting of a single point
therefor set "Set-2" cannot be used in row 2. "
I want to constrain all the face, not only a single point.
Somebody have any idea ?
Regaerds,
I use Abaqus CAE and I want to applied periodic boundaries conditions at one square RVE.
I want that tow parallel face have the same deform. I use Constrains -> Equation but when I choose set ( geometry ) I have the message : " All terms except the first one must use set consisting of a single point
therefor set "Set-2" cannot be used in row 2. "
I want to constrain all the face, not only a single point.
Somebody have any idea ?
Regaerds,