Tom76
Structural
- May 8, 2012
- 9
Hello,
I'm trying to develop a API Program to automatically apply Loads to specific Curves and Points.
The Curve part of the program is currently working, the problem I have is with the Points part. The Load should be applied on the top-most point of the structure (a scaffold in this case). The problem is how to select this specific point.
Does anyone know what procedure/commands I should use to select the top-most point?
Regards,
Tom
I'm trying to develop a API Program to automatically apply Loads to specific Curves and Points.
The Curve part of the program is currently working, the problem I have is with the Points part. The Load should be applied on the top-most point of the structure (a scaffold in this case). The problem is how to select this specific point.
Does anyone know what procedure/commands I should use to select the top-most point?
Regards,
Tom