Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Piezomaterial in ANSYS workbench

Status
Not open for further replies.

Engy Rashed

Mechanical
Nov 2, 2016
3
mp,perx,MATID,804.6

Could you please tell me in which unit I should put the permitivity of piezomaterial in commands in ANSYS workbench ??

I am solving an ultrasonic cleaner , trying to know its amplitude of displacement but I get very large numbers I don't know why ?
Anyone can help me in this ?
 
Replies continue below

Recommended for you

SI unit is F/m and dimension M-1·L-3·I2·T4. Derive what to use according to the consistent unit set that you are using in your analysis.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor