Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Piping analysis using ANSYS MECH - both ends movements specified

Status
Not open for further replies.
coolniks37

coolniks37

Mechanical
Joined
Feb 7, 2013
Messages
85
Location
CA
Can i do a ansys mech analysis with the following conditions?
I have a pipe (geometry) of 20m length.
At inlet, the nodes should have movement -20m,-60m,0 as there is a force causing that?
How the movement at outlet can be found out using ANSYS?
I have all data relating to thermal expansion, gravity etc
 
Sort by date Sort by votes
A 20m length of pipe with movements of -20m , -60m, 0 - are you kidding??
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

R
  • Locked
Guidance on Settlement Analysis of Steam Generator in Oil Plant Using ANSYS
Replies
0
Views
792
Rabea-19
R
O
  • Locked
  • Question Question
ansys civata
Replies
0
Views
2K
oktaeng1
O
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H
S
  • Locked
Concrete Shrinkage modelling with ANSYS
Replies
1
Views
2K
crshears
crshears
M
  • Locked
  • Question Question
ANSYS Mechanical Scripting: how to delete an existing heatflux?
Replies
0
Views
816
MihailW
M

Part and Inventory Search

Sponsor

Back
Top