Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Placing coordinate systems in shop doc

Thread starter engtipsuser100
Start date May 7, 2016

Status: Not open for further replies.

May 7, 2016

engtipsuser100

Mechanical

Greetings!

Using NX6 I would like to improve our shop floor documentation by changing the default look of coorindate systems. I am only aware of the calibrate option in visual preferences, but I would like to customize it in a deeper way - for example: changing the letting size, removing the XY, XZ, YZ planes, etc.

Thanks in advance!